eVic Mini 2 Mod Gold

eVic Mini 2 Mod Gold

The eVic V2 Mini mod uses replaceable 18650 batteries and is one of our favourite mods. Upgradeable firmware means you can upgrade the features on the mod by plugging it into your laptop.


*Ships to NZ Only*

WATCH VIDEO

Regular Price: $109.95

Special Price $89.95

WHAT'S IN THE BOX?

  • 1 x eVIC Mini 2 unit
  • 1 x USB cable
  • 1 x skin
  •  instruction manual

SPECS

  • Power and range: power depends on 18650 battery used, 1W-75W (firmware upgrades may increase wattage in future)
  • Modes: wattage, temperature control (Ti, Ni, SS316), bypass mode, TCR (temperature coefficient of resistance)
  • Coil resistance minimum: 0.05-1.5ohm for temperature control, 0.1-3.5ohm for wattage and bypass mode
  • OLED screen shows: wattage, voltage, coil resistance, temperature control, battery charge, vape timer, clock
  • Display functions: puff counter, memory for last setting used, set screen protection time, key lock, flip screen, digital and analog clock, logo mode
  • Safety: automatic cut-off after 10 seconds, short-circuit protection, weak battery, low battery, atomizer low, temperature protection, temperature alert/overheat protection
  • Connection threading for tank: 510 (standard)
  • Charging: micro USB cable
  • Material: stainless steel
  • Dimensions: H: 82mm W: 38.2mm D: 22.2mm
  • Weight: 100g without 18650 battery, 150g with 18650 battery

FEATURES & TIPS

  • Switch on and off press the power button 5 times.
  • To decrease or increase the wattage hold the left or right hand side buttons and press the power button to set.
  • Left-handed? Flip the screen by pressing the two buttons simultaneously until the screen flips.
  • Change to wattage mode press the power button 3 times to enter into the modes, and use the right side button to select power mode, then press the power button to keep the setting.
  • Check the puff counter by pressing the right side button until the AMP row flashes. Select puff and press the power button to set.
  • Set the clock by pressing the power button 3 times to enter the menu. For digital display, press the left button to enter into the day/time/year, then press the power button to set. For analog/dial display, press the power button 3 times to enter the menu. Press the left button to set the hour/second hand, then press the right button for numerical display and press the power button to set.
  • Bypass mode sets the unit up to sense the coil resistance and use maximum power for that resistance. As the battery loses its charge, the power will decrease.
  • TCR/temperature mode is problematic with the eVic Mini 2, and we don't recommend this mod for use with temperature control.

TROUBLESHOOTING

  • Key: wattage mode = power mode; TC mode = temperature control or TCR
  • Unit not working/charging? Try a replacement 18650 battery and see if this solves the problem.
  • Display reading "Over 10s Protection". The power button has been pressed for over 10 seconds and the unit has automatically shut off to prevent overheating/short circuit.
  • Display reading "Atomizer Short". The unit has detected a short circuit from the coil. Try changing the coil and try again.
  • Display reading "Weak Battery" while in TC or wattage mode? The voltage of the battery is below 2.9v and the power output of the battery has been reduced accordingly. Charge the battery or replace with a fully charged battery.
  • Display reading "Low Power Alert" The voltage of the battery is below 3.3v, and if you continue to press the power button, it will read "Battery Low Lock". Charge the battery or replace with a fully charged battery.
  • Display reading "Atomizer Low Alert". The coil resistance is below 0.1ohm in wattage mode, or 0.05ohm in TC mode and the unit cannot operate. Replace with a suitable coil for your setting.
  • Display reading "Protection" in TC mode? The temperature of the coil is higher than the set temperature. Replace the coil or wait for the unit to cool down before trying again. 
  • Display reading "Device Too Hot". The unit's temperature is over 70C and has shut off to prevent a short circuit. Wait until the unit cools down and try again using a lower wattage or temperature setting.

You might also like

LG HE2 18650 Battery 2500mAh

LG HE2 18650 Battery 2500mAh

$14.95
LG HG2 18650 Battery 3000mAh

LG HG2 18650 Battery 3000mAh

$19.95
Smok X-Baby TFV8 Tank

Smok X-Baby TFV8 Tank

$49.95